Note: This functionality is only available in AutoTURN and AutoTURN Pro.

Continues generating an existing turn simulation in the drawing using the SmartPath Tool that was used to generate the simulation.

Continue Simulation Dialog Box

Continue Simulation Mode

Continue the existing simulation

Pick a simulation and continue the simulation.

Continue a copy of the simulation

Pick a simulation to copy and then continue the copied simulation, leaving the existing simulation intact.

Continue as a new simulation

Pick a simulation and begin a new simulation that starts from the end of the existing simulation (leaving the existing simulation intact).

Destination Layer/Level

The simulation will be continued using the existing simulation's layer/level if Continue the existing simulation is selected.

If Continue a copy of the simulation or Continue as a new simulation is selected, two more options are available:

• Select Layer/Level and then select the desired layer/level in the list.
• Select New Layer/Level and then type a new layer/level name in the box.

Hint: Alternatively, you can continue an existing turn simulation by clicking any of the SmartPath Tools on the ribbon or toolbar, and then picking a point inside the wheelbase of the vehicle at the end of the simulation to be continued (instead of picking a blank area in the drawing to pick a start position). The vehicle and properties of the existing simulation will be used to continue the simulation.