To Set the Stall Numbers Parameters:

1. Click Design Parameters on the ParkCAD toolbar or ribbon.

2. Click the Stall Numbers category. The following dialog box displays:

Design Parameters - Stall Numbers

3. Select the Position of the stall number text by clicking in the display image (the three options are Inside, Center, and Outside).

4. Specify the Height (H) of the stall number text.

5. Specify the Width (W) of the stall number text.

6. Specify the Offset (O) from the end of the stall to the stall number. (This setting is available for Inside and Outside options only. It is measured from the inside when the position is set to Inside, or measured from the outside when the position is set to Outside.)

7. Click OK.