Adds and removes stall numbers from rows of stalls in lots and rows.

Stall Numbering Can Be Used in the Following Ways:

• To Add Stall Numbers

• To Remove Stall Numbers

To Add Stall Numbers:

Stall Numbering

Click Stall Numbering on the ParkCAD toolbar or ribbon. In the Stall Numbering dialog box, choose which stalls the numbers will be drawn in from the Display list. In the Stall Numbering dialog box, type a Start Number. In the drawing, click inside the first stall of the row side you want to add stall numbers to. Repeat step 4 until you are done adding stall numbers then right-click to end the tool. Note: This tool will add stall numbers to a single row side at a time – not both sides of a row at the same time. Hint: To continue the numbering in subsequent row sides, ensure that the Increment check box is selected before numbering the first row side. To number accessible parking stalls as well, select the Include Accessible check box.

To Remove Stall Numbers:

1. Click Stall Numbering on the ParkCAD toolbar or ribbon.

2. In the Stall Numbering dialog box, click Remove Numbering.

3. In the drawing, click inside an end stall of the row side you would like to remove stall numbers from.

4. Repeat step 3 until you are done removing stall numbers then right-click to end the tool.

Hint: To remove the stall number from a single stall click Edit Stall, click Exclude From Numbering then click Apply. Renumber the row side by clicking Stall Numbering to re-number the row side and subsequent rows if necessary. This stall will always be excluded from Stall Numbering operations until this setting is changed.