Inserts symbols into stalls, islands or exclusion zones in parking lots. Symbols can be inserted anywhere in an island or exclusion zone. When inserting symbols into stalls, they will be centered in the stall.
The Insert Symbols Area Tool Can Be Used in the Following Ways:
|
Insert Symbols Area |
To Insert Symbols into Parking Lots:
-
Click  Insert Symbols Area on the ParkCAD Insert Symbols flyout or ParkCAD Insert Symbols toolbar or ribbon.
-
The Insert Symbols dialog box will display similar to the dialog box to the left.
-
Select a symbol from the list.
-
Specify an Angle value as desired.
-
Click in a stall, island, or exclusion zone.
- Repeat steps 3 to 5 or right-click to end this tool.
To Remove Symbols from Parking Lots:
-
Click Insert Symbols Area on the ParkCAD Insert Symbols flyout or ParkCAD Insert Symbols toolbar or ribbon.
-
In the Insert Symbols dialog box, under Mode, click Remove Symbol.
-
In the drawing, click inside the symbols that you want to remove from the parking lot.
-
Repeat step 3 or right-click to end this tool. |
